Interested to Buy Any Domain ? << Click Here >> for more details...
in three pin pluge there three pins one is phase and second
is earth third is nutral why nutral high diameter compare
with phase and earth
- 10 Answers
- 18764 Views
- Radiant, I also Faced
- E-Mail Answers
Answer Posted / gajanan
actualy earth socket has large diameter as compared to
phase and neutral.
it is for the safty.
whenever abnormal condition occures, abnormal current
should be earthed quickly and for that resistance of path
should be minimun and
resitivity= R*l/A ;
resistivity inversly prportion to area:A
so when earth socket hole be large abnormal current goes to
zero without any accident.
| Is This Answer Correct ? | 76 Yes | 8 No |
Post New Answer View All Answers
physical identification of HT & LT panel
what is the significance of tan&delta and how it performed in power transformer
why the check zone and main zone are used for Busbar Protn. scheem?
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
when we have to use UPF wattmeter and LPF wattmeter? what is the difference between UPF and LPF wattmeter in terms of construction?
DG cranking voltage?
How much depth n width required for laying of 1X70 Sqmm Cable in Desert???
what are the 4 rules to start the motor?
How can two 3 phase transformers of same KVA and Voltage be connected in parallel?
what is the difference b/w ATS and HTS?
How we can calculate the consumption in kwh of motor on basis of kw @100% load, @50% load & @ no load.
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
What is FTA card? How it works?
Which device of PlC does share load between DG sets when DG are running in perallel?
