Answer Posted / nitesh kurdia
The ratio of the sum of the individual non-coincident
maximum demands of various subdivisions of the system to
the maximum demand of the complete system.
Sum of Individual Max. Demands
diversity factor=--------------------------------
Max. Demand on Power Station
Is This Answer Correct ? | 32 Yes | 1 No |
Post New Answer View All Answers
How do I calculate/select Droop CT ratio for various capacity of generators?
sir iam from electrical and electronics branch ,can i appear for the hpcl offline requirtment? if yes please mail me on vikram_raju25@yahoo.co.in
what is the necessity of under ground cables ??
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
What is use of starter and choke in tube light
how to select electronic timer(Star-Delta) setting for diff. rating motors
how open delta PT works & what is its construction?
What are safety device in vcb and acb?
Dear sir, I have completed DECE in the year 1995. I have work experience in HT and LT LINE more than five years. Now i am doing BE in EEE from rajasthan university. After completion of BE,can i apply "C" Licence sir? Please reply.
what is 30-phase of transformer
What is difference between Harmonic and Non harmonic Capacitor Bank?
What is EMC filter in VVVF Drive ?