Interested to Buy Any Domain ? << Click Here >> for more details...
how much loading in terms of ampere can put on 5 MVA,33/11
KV TRANSFORMER having rated current 263 Amp ?????????
- 11 Answers
- 36870 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / serwox
Answer depends on what percentage overload a transformer can
accept. For a tx that can accept a 120% overload, the
current is 315A.
| Is This Answer Correct ? | 20 Yes | 5 No |
Post New Answer View All Answers
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
What is the theoretical reason for the size of a zig zag grounding transformer to be 1.732 times less than that of a wye-delta grounding transformer used for the same application?
Define gain margin?
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
what should be the ideal gauge of wire (In sq mm) for different loads in Ampere?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
What are the site acceptance tests for power cables, DG Sets, LT panels & 30kVA UPS ?
What is the loss of power of transformer 220kv/33kv,63/80mva of % imp12.05 at 80%load
How many sprinklers should be in one pipe line?
why only exciting current is shown not primary current in transformer???
what happen if the parallel generator phase angle shift by 1 degree in manual mode
size of condotory fron voltage level
How does HT work & Voltage required?
how to calculate voltage drop and followed by cable calculation?is there avail in formula?
errection check list for transformer maintenance
