Why not implimenting power factor in Diesel generator
- 6 Answers
- 9309 Views
- HP, I also Faced
- E-Mail Answers
Answer Posted / bhupal singh
Power Factor is the property of load. Generator is a source
of power. So it can not be corrected thru generator. However
Synchronous generators can regulate power factor by
adjusting it's excitation current.
| Is This Answer Correct ? | 4 Yes | 6 No |
Post New Answer View All Answers
What are merits & De-merits of State-Space Method? What is series programming, parallel programming, general programming & direct programming ? And, difference between these programmings Techniques ?
On a 3 winding transformer YNynd11, how do you apply REF protection to the Delta tertiary winding that is supplying auxiliaries to a substation?
what is the use of current transformer in power transformer secondary side.?its connectyed in WTI
How do we arrive at selecting reactive capacitance value as 30% of h.p rating of motor?
The D.C. spark test is applicable to single conductor cable & assemblies of insulated single conductor cables without insulation shield,metallic sheath or metalic armor?
What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
Which types of gate insttaled in static switch. Please give me answer.
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
What is the difference between electronic regulator and ordinary rheostat regulator for fans?
one electromagnet is called
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
How to calculate earth wire load by formula
How to calculate the Efficiency of Chiller
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
