how much loading in terms of ampere can put on 5 MVA,33/11
KV TRANSFORMER having rated current 263 Amp ?????????
- 11 Answers
- 33694 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / har
300amp
| Is This Answer Correct ? | 8 Yes | 10 No |
Post New Answer View All Answers
what are the protecyion of transformer & generators
what is the relationship between current&voltage in practical purpose ?
State ohm’s law?
neutral earth resistance testing is it possible for transformer while in load condition
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
main difference between ac and dc?
why dc is used in control circuits for MV & LV switchgeras instead of ac
kVA rating of ordinary transformer is increased when connected as an auto transformer because A transformation ratio increased B secondary voltage increased C energy is transferred both inductively and conductively D secondary current increased
LET ME NOW MORE ABOUT icu and ics for circuit breaker. how we calculate the rating of circuit breaker and i c u and ics values
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
What are the commonly used schemes for the bus zone protection?
How to calculate impedance volt in Transformer?
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
Why you want to join non technical field when you are an engineer?
In PFI plant one stage capacitor connection is directly connected(with out megnetic contact controll). but why?
