On what basis no of earth pits are to be decided either for
transformers or for equipment?
Answer Posted / vikramsenareddy
Ans: Transformer secondaty sholud have neutal point. This
we brought from earth. neutral point is earthed and
connected to T/F. for this we required one earh pit. and
for body earthing we should have another earh pit.
structure earthing for this another earth pit.
For an equipment we required only one earth pit for body
earthing and electrical accessories earthing( like
motors,switch gear, electronic instruments).
Is This Answer Correct ? | 23 Yes | 13 No |
Post New Answer View All Answers
Sir, I have applied for the of Jr.engineer(Electrical & Electronics) & ASST. LOCO PILOT at ALL RRB BOARDS. please send me all RRB Boards solved papers in the year of 2001 tO till date. i requested send me the papers to my id as soon as possible (jet_0991@yahoo.com). (This is very urgent) Thank You,
What do you mean by transformation ratio of instrument transformer?
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
how can we understand that where we have to use ac or dc coil for solenoid valve and why?what is the different between coil of ac and dc explain please.
how to setting Load amps tripping time and extra settings for load Transformer protection relay with RMU panel using C&S model relay..?
why we cannot protect 100% winding of an alternator by using differential protection?
what is the difference between single ratio, multiple core and multiple ratio, multiple core ? please explain.
why is control bus bi-directional?
How cmd is calculated in case of energy neters
what is transient stability analysis means?
what happen when increase or decrease size of lamp,light.glass.
why 1.7Uo for HV cable Hi pot test?IE standard why?
What is transient response?
Can you please explain creepage distance in detail, for a 6.6kV cable head what must the distance be and how do you determine it?
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?