Interested to Buy Any Domain ? << Click Here >> for more details...
What is C.T, why it is used and what care should be taken
for that while connecting?
- 20 Answers
- 30181 Views
- Bhushan Power Steel, I also Faced
- E-Mail Answers
Answer Posted / manogna
CT stands for current transformer.primary wdg of C.T is
connected in series with the load and it carries load
current.it consist of few turns. the secondary wdg consist
of more turns and instrument is connecte directly across
it.Its secondary is kept short-circuited always.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details
what is the role and fuction of automatic transfer switch in rotary ups
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
Can u Explain about the electronic trivector meter and the use of data converters in them?
what size steel armoured cable is required to support 1500kva capacity. would 70mm squared be enough or would I need 90 or 120mm squared 3c plus earth
Explain cmrr?
how a.c. genarator control power factor when its conected to grid supply by incrising or decresing excitation voltage.
i am going to attaned the engineer (disign)iterview at HAL please give me duid line
What are the advantages and disadvantages of negative feed back?
If Neutral Grounding Resistor (GR) failed/shorted. Is it repairable.
What is meant by cold loop test in instrument
How we can calculate the Amps for the cable Ex:- For 1sqmm wire how many amps we can draw (calculation)
what is model question rrb junior engineer electrical gr.II
What is value of earth resistance required for substation and equipment earthing and what are the reference guidelines
Explain the operation carried out in thermal power stations?
