how to use single phase supply for a three phase equipement.
- 12 Answers
- 17379 Views
- I also Faced
- E-Mail Answers
Answer Posted / siddharth tayade
the diffrence between 3phase and single phase voltage is
only depends on the angular displacement . if we made the
anguler displacement 0deegre , 120deegre, 240deegre using
capacitor . then we can adopt the 3phase supply voltage.
| Is This Answer Correct ? | 45 Yes | 0 No |
Post New Answer View All Answers
In a synchronous motor. if start is running at high speed. What will be the starting torque : Higher Lower Zero
What is the practical way to calculate the cable size for known ampere load?
Pl.brief me about Electrical power distribution system from Main generating station to Industry.What is the use of in between station.
what are symmetrical and non symmetrical components in electrical installation.
What is the effect on 3phase induction motor if current setting knob of DOL kept at minimum current?
if we apply 1000ADC instead of 100ADC or We apply 50ADC instead of 100ADC,What will be happened in the test result value.Pl explain
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
Draw a block diagramof Three UPS systems connected in Parallel mode?
What is meant by harmonic distortion?
HOW MANY TYPES OF FUSE?
how to changeover ups in this power failur time?
what is ATS & RING MAIN UNIT in Distribution System?And its Function.
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
what is the soft starter principle? how is connection diagram? what is the procedure for checking the connection?
Let me know that how i calculate the alternator sub tranciant reactance and tranciant reactance.
