Interested to Buy Any Domain ? << Click Here >> for more details...
Do you know how to maintain a generator, if so what are
those maintenances?
- 4 Answers
- 12403 Views
- I also Faced
- E-Mail Answers
Answer Posted / satya dev ( knight frank)
For Engine side
A- Check - Every day- check battery voltage, oil level etc.
B- Check 300 hrs/6 month- replace lub oil, fuel filter ,
water seperator & super by pass filetr, also change the
Loub oil.
C- Check - 1500hrs/1 year - repeat B check & tighness the
tappet, rocker lever , change the Air filter.
D - Check - 5000-6000 hrs/2 year- repeat B & C check &
Carried out the following activity---
1- Calbribation of fuel pump
2- Calibration of turbocharger
3- Calibration of Injectors
& replace all gasket form head & check the piston if any
spot found will replaced immediataly.
| Is This Answer Correct ? | 14 Yes | 3 No |
Post New Answer View All Answers
What happens if the series current double?
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
my diploma certificate in my higher education college
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
XYZ
why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.
Inductor and capacitor........power in one phase and ...... in it another phase.
What are the advantages of vscf wind electrical system?
before synchronizing an alternator,power factor is leading ,why?
how to get electrical supervisor competency certificate in gujarat. i did 3 year diploma in electrical
Is it possible to use a S1 duty class motor for crane application (S4)? If not, why?
What are all present producing cost of Per KWH of various Fuel?
What is the mechanism of WTI
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
describe the A.C. Generator Testing procedure
