Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE DIFFERENCE BETWEEN PLC AND DCS
- 55 Answers
- 129101 Views
- ABB, Adani, Adani Power, GMR, IIUC, I also Faced
- E-Mail Answers
Answer Posted / satishpatel-bilimora
plc is a progrramable logic controllers & dcs is a
distributed control systems. plc is a on/off controller.it
controls the only machine on or off. dcs controls the many
plc at the time.
| Is This Answer Correct ? | 62 Yes | 107 No |
Post New Answer View All Answers
What is Erosion in a control valve?
What is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
Gas equation
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
Area classification, Equipments, Gas groups, temperature classification, Ingress protection, Fire Extinguishers.
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
What is zener diode? What is voltage regulator?
key exchanges in wpa,wpa2,tls
What are the uses of orifice plates?
Any one can help me to identified, how can we interchange the device in FF
what is interface level and how it is calibrate?
Differentiate between ultrasonic flowmeter and radar type flow meter
Explain bernoulli’s theorem. State its application.
i need some objective type questions in instrumentation
i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure
