Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / gurmeet singh
No, Not all tapered pipes are nozzles.
It may be diffuser or simply a pipe depending upon the folw
conditions like mach number and pressure drop.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
how can i replace annular plats in tanks
Under what circumstances would there be an increase in pressure in a diver¬gent nozzle ?
on which date sail exam is held & what the criteria for this exam
What are the causes of L.O. high temperature?
Name the only five parts of lathe machine?
how to calculate bearing width
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
Why rockets using liquid hydrogen have higher specific impulse compared to liquid hydrocarbon ?
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
Explain the procedure of charging reciprocating compressor?
what are the parameters are selected while manufacturing a single cylinder block?what are the different kind of test is conducted on it so that it can withstand with all those condition which required to run the engine efficiently.which force is act when piston slide inside the cylinder.
how to define nomenclature of bearing.
What do you mean by annealing?
Which material amoung EN8 and EN24 should be selected for the designing of the shafts of rotary kilns
What is method to calculate the noise level at any point of duct if duct dimensions and air flow is known?
