Two 11 kv lines are feeding to common bus in a
substation,I have one set of CT & PT(3ct,2pt), How can I
measure both lines power using single set.
- 6 Answers
- 9970 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / sb
Connect your CT & PT on the common bus to obtain combined
power of both the 11 kV lines.,
| Is This Answer Correct ? | 14 Yes | 5 No |
Post New Answer View All Answers
how to conduct dc resistance test for rotor of an alternator and how to measure the rotor dc resistance value theoritically?
in 1-phase 230v,how in 3-phase 440v. in each phase in between 230v.
why Lightening Arrester Probe sharp at Top of telecom tower.
What is the limitation of kirchoffs law?
State magnitude criterion.
how did i get the competency certificate as electricle supervisor. iam completed my b.tech.but i dnt have any experince, this certificate is required for applyng ongc mangement trainees. what should i do sir please suggested me
Can 33kva/415v transformer be run underground? If the answer is yes why and if the answer is no why?
Anybody know how schematic diagram for reverse power relay? RPR for generator protection
What is different bewteen low or high impedance busbar protection scheme
How to measure size of cable on a given load
harmonics filter
A d.c. Shunt motor is found suitable to drive fans because they require?
What is dynamo?How it works and what is the function of dynamo in a DG.
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
why should the primary of transformer be connected in delta in a heat run test?
