Interested to Buy Any Domain ? << Click Here >> for more details...
1KVA transformer of different frequencies of
50hz,100hz,500hz&1000hz. which one of these transformer has
big size? Give reason
- 16 Answers
- 39567 Views
- Ecil, Engineers India, MahaDiscom, I also Faced
- E-Mail Answers
Answer Posted / kishore
X(1 KVA) 50 HZ n Y(1 KVA ) 500 HZ
E = 4.44 f * FLUX * N
that is emf durectly proportional to flux which is f*B*A
B- flux density n A= area of c/s of transformer
as KVA reting of both are same n hence
X (f*B*A) = Y (f*B*A)
as frequency of X is smaller than Y so area of c/s of X
must be larger
hence 50 HZ transformer is largest and so on
kishoresahoo@ymail.com
| Is This Answer Correct ? | 39 Yes | 8 No |
Post New Answer View All Answers
Why r u using pf panel. what the uses
How to calculate flow of water delivered by pump when pressure & size of pipe line is given
why use phase displacement in transformer.and effect of phase displacement on transformer
How much depth n width required for laying of 1X70 Sqmm Cable in Desert???
What is the loss of power of transformer 220kv/33kv,63/80mva of % imp12.05 at 80%load
A motor running with lenze frequiency inverter stops if I REDUCE SPEED with 25% load.If I run it in High speed and medium speed running smoothly with full load.please help me to solve it.
1600 KVA ka transformer hi aghar lt side par 800A aur voltage 420 ho to HT side ki cable ki rating keya ho gi?
How do apply electrical 'c'license......pls advice
If you have an earth with pilecap then your resistance is really low. why and how?
what percent do you derate your copper wire when you change from copper buss to copper wire
what is the effect of higher value of GD???
a starter used for squirrel cage induction motor?
What is installed in PAC that is control the humidity
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
