Answer Posted / satya dev ( knight frank)
In that question, the follwing factors are not mentioned
for what current load u are selecting the cable size---??
for what the calbe length using for system---????
for what type of load has to be conneted--/?????
If above factor are availabe then we can claculate the
same. there is no exact formula to calculate the size of
cable without all above factors
Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
I want formula to calculate current loss with distance in km.I searched many sites but didn't right answer.Plz reply me
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
Vibromotor 252MV 1/4HP2P..what is mean by 252MV?
What are the basic elements used for modeling mechanical translational system?
Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed
How will polarity test of Dy5 Transformer ?
What are the basic properties of signal flow graph?
what is the star delta connetion and how can do it a three phase motor with control witing with picture
What is block diagram?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
How to do stting of vl250 siemens MCCB
why swityard is necessrry requirement in any bis power distributin systems?
when will be the iocl interview results ifaced the interview on september 8 th
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above
if sf6 gas low in gis what will happen