why 4 to 20 ma ,why not 0 to 20 or 3 to 15 or anything
- 19 Answers
- 43768 Views
- Honeywell, TCS, TN, I also Faced
- E-Mail Answers
Answer Posted / imran
The minimum value is 4 mA is because to avoid any confusion
of out put at lowest value.
| Is This Answer Correct ? | 10 Yes | 62 No |
Post New Answer View All Answers
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.
Any one can help me to identified, how can we interchange the device in FF
Q1]IF THE RANGE FOR FLOW IS -35 TO 125 WHAT WILL BE THE SPAN FOR ABSOLUTE AND FOR NORMAL? Q2]HOW TO CALIBRATE CAPILLARY TYPE LT? Q3]HOW MANY ERROR CALCULATIONS ARE THERE USED IN PROCESS INDUSTRIES? Q4]HOW TO CALIBRATE TEMPERATURE TRANSMITTER? Q5] HOW TO CALIBRATE LEVEL TROLL AND HOW TO CONNECT? Q6]PLEASE TELL ME THE BASIC FOR INSTRUMENTATION WHICH IS APPLIED FOR CALIBRATION AND FOR ALL? PLEASE MAIL THE ANSWER TO honest_yes@yahoo.in
what is a half wave, full wave, and bridge rectifer.
Explain the difference between plc and cnc?
What is the difference between uv and ir scanners? and what is the workig principle of both
What is shielding effect?
what is function of switch, and how is it work, explain with difination
please someone tell me what is function of vibration sencer and how many types and how to control viberation.please. my id is jimmykhan077@gmail.com
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
What is the basic difference between Modbus and CAN Open Protocols
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
