Interested to Buy Any Domain ? << Click Here >> for more details...
What are the tests to be taken on a transformer and
generator?
- 12 Answers
- 41472 Views
- Honeywell, I also Faced
- E-Mail Answers
Answer Posted / zahid ali
On transformer
1- Insulation Resistance
2- Di-electric loss Factor or Tan delta or Power Factor test
3- Polarity & Vector Group Test
4- Transformer Turn Ratio Test
5- Sweep Frequency Response Analysis
6- Temperature Rise Test
7- AC leakage Test
8- Dissolve Gas Analysis Test On Oil
9- Short Circuit & Open Circuit Test To determine losses
On Generator
1- Insulation Resistance & Polarization Index
2- Hi Pot
3- Short Circuit Test
4- Power Factor Tip up test
5- Partial Discharges Test
6- El Cid Test (electromagnetic core imperfection detection)
7- Retaining Ring Test (Ultrasonic)
8- Recurrent Surge Oscillation Test on Rotor (RSO)
9- Low Resistance Test
10- AC Leakage Test
| Is This Answer Correct ? | 48 Yes | 7 No |
Post New Answer View All Answers
what is R Core Transformer. how it differs from normal transformers. dont search in net and post the answer.
Give idea about General Engineering. From which book i can study this topic. Pl. reply me via email. My email is ravi@bhelhwr.co.in, also give the name of book/website, from where i can prepare it.
what heppend if we are connected u1-v1-w1 as a star point in the place of u2-v2-w2 in power genration
How many types of instrument cables are there?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
What is icu and ics in Acb and how many time icu or ics passes from breaker?
If I want to buy a new Xformer for my plant what are the main parameter will I need to check?
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
how to select rating of HT Panel
Why field rheostat is kept in minimum position?
please send me previose rrb junior engineer qustion papers
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
Why corona leads to production of Ozone and glow of the color VOILET?
What do you mean by the zone of protection?
what is the necessary of using inductance property in transmission lines even through resistance is used to opposes the high current flows in that?????
