Interested to Buy Any Domain ? << Click Here >> for more details...
why does mA signal preferred for signal transmission?
- 12 Answers
- 25994 Views
- Emerson, I also Faced
- E-Mail Answers
Answer Posted / r santhosh kumar
most probably mA signal is preffered in signal transmission
because the voltage in the cable may be affected by the
sidewise power cables which are running with this cable
(in the same cable tray).
| Is This Answer Correct ? | 12 Yes | 3 No |
Post New Answer View All Answers
How will you calibrate PID controller? explain with example.
what is piezoelectric transducer?give an example in power plant n state its principle?
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
Which products are available in the Mass Systemswitch and System Manager AC range?
What is the use of GMV in turbine?
sir,would you please send me the Hindustan petroleum corporation limited papers(HPCL).my e-mail ID is ujjwal_sharma1983@yahoo.com
what is the reason while warning lamp is on while the engine is cranking?
what will the sending unit in the fuel gauge utilizes?
Explain bernoulli’s theorem.
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
what is zero and span ?
3. Differentiate between ultrasonic flowmeter and radar type flow meter.
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
