Do you know how to joint the H.T and L.T Cables?
Answer Posted / vinothbhabu
hello dear,jointing the cable not by using transformer or
by fevicol,and its not a simple like paper r wood jointing
by fevicol..
by using the heat strinkable method cable jointing will be
done,the heat strinking method gives high insulation to the
cable at jointing end,it can be used for jointing ht panel
board at the termination end,the kit used for the heat
strinkable is heavely insulation material,the joint will be
done by heating material...
for jointing the LT to LT cable above 6
sqmm,10,16,35,50,70,90,120,150,185,240,300,400,sqmm cable
by jointing the FERRULE LUG between the cable joint by
using cripping tools and then insulation tape will be
rounded it heavely......
| Is This Answer Correct ? | 114 Yes | 17 No |
Post New Answer View All Answers
How CFL &T5 tube light glows?
What is the rotor frequency of 10 Hp 1440 RPM 50HZ 415V ?
how can we determine size of a cable by knowing the kw or current rating of a load?how can we calculate the resistance box of a slip ring motor?
What is a difference between indoor transformer and outdoor transformer of same rating
How dia computation perfomed in cold rolling mills .
What is the role of feedback in a closed loop control system?
How I can Compare 120v/60Hz versus 220v/50Hz ? Please tell me both advantage and disadvantage ......
what is the difference between electrical and electronic choke?
State kirchoff current law?
Post possible questions for Power Factor Panel FAT / SAT
WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?
high voltage transformer input voltage,current and amps rating..distributed transformer input voltage,current and amps rating...
What is turn ratio of a transformer?
working principles of cf lamp,incandescentlamp and f lamp?
what are the advantages and disadvantages of speed control of 3 phase induction motor by varying frequency explain with drawing