Interested to Buy Any Domain ? << Click Here >> for more details...
why is the vector group analysis done in transformer tests
- 28 Answers
- 74308 Views
- K K Rao, Lloyds, Nicco Engineering Services Limited, Qatar Petroleums, I also Faced
- E-Mail Answers
Answer Posted / saju thomas
Mostly using transformer phasing arrangements are
DYn11,DYn7,DYn5.This is related to phase
displacements.vector group test is doin for analaysing
transformer phaseangles as per the phasing arrangements
like DYn11 or DYn7 or ...
| Is This Answer Correct ? | 40 Yes | 11 No |
Post New Answer View All Answers
how to work droop ct in generating station
what is the disadvantages of common earthing for AC and DC equipment? (i am talking about inverter control room and inverter duty transformer earthing is common...?)
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
What is the purpose of stablization resistor in high impedance bus bar protection
A car's starter motor draws a current of 100 A at 12,0 V when starting the engine. The mechanical power required to turn the engine is 960 W. At what rate is energy from the battery converted to non-mechanical forms of energy?
what is the solution for meger test failed the MV cable?
why constant voltage transformer should be start without load? and if started then what will happen?
Difference of induction motor & servo motor ??
how to measure earth resistance of a substation
what happen when we add mentos in cold drink?& why?
According to conduit size which size wiring & how many wires can we provide wires in conduit & how can we select conduit size accordingly?
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
what is the current setting for different relay protection for transformer .
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
If Polarization index of motor 8.75 at 500volts of medium voltage 4.16 KV motor what this mean winding good or bad pl answer if any reffrence book give me the link
