Interested to Buy Any Domain ? << Click Here >> for more details...
What is min and max voltage between earth and neutral/phase
if it perfect earthing?
- 37 Answers
- 257827 Views
- Epoch, ISS, ITC Infotech, L&T, Power Works, Statex, Sterlite, Wipro, I also Faced
- E-Mail Answers
Answer Posted / m.mousa
This will depend on the earthing arrangment
plz check IEC 60364-5-54 Electrical installations of
buildings - Selection and erection of electrical equipment -
Earthing arrangements
| Is This Answer Correct ? | 83 Yes | 41 No |
Post New Answer View All Answers
What is inrush current?
why it is not advisable to run low rating (19KVA) DG sets in parallel for long durations even though they are provided with droop ckts (QDC)
What is different between Difnit time and instatous over current relay
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
What are the causes for the failures of sandwich type (Al) busducts?
how to calculate transformer turn primary & secondary side 11kv to 420v
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
Write the force balance equation of ideal spring element.
How much ph is maintained of water resistance starter for slipring induction motor ?
Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?
Refernce currents are to be generated using refernce cueernts how can this be done
What does the term “voltage regulation” means?
sir pls send the je exam - 2008 and other model question papers..
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
