what is anchorage?
Why anchoring of reinforcing bars necessary and what are
the shapes ?
Answer Posted / selvamani
ancorage bars are necessary to provide bond between the
concrete and the bars....
Is This Answer Correct ? | 5 Yes | 12 No |
Post New Answer View All Answers
What is the ideal size of the living room ranges from small to large size?
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
a) we have 30nos., 300mm dia, 4m length double under reamed piles.calculate excavation quantity.b) tell concrete qty. also.
150mm bricks size how many use 4.14 m3
1) What is meant by C-soil in geotechnical Engineering? 2) What is Eve board? 3) What will happen when heat is applied to cement? 4) what do you understand by the lateral dimention ?
if the nitrates more than 45mg/l in water lead to disease then what is it called
How to calculate material and labor required for 100 m2 plaster?
What will you do if you encounter problems like accidents?
what is the dimensions of river sand truck trailer or trolly ?
Can we use concrete of slump cone in cube casting in which we have already measured slump?
how many litres of enamel paint required for 5000 sft of site??
GIVE US DETAIL OF YOUR PRESENT EMPLOYMENT STATUS?
suppose we have a tendency to make a hole on the surface of the simple supported beam, than where we goes to make it?
Which is the direction for positive angle?
pls mail some more tecnical qustions at msaranya2610@gmail.com