Question { IBM, 9880 }

How can you backup and restore DC

Answer

Open NTBACKUP by either going to Run, then NTBACKUP and
pressing Enter or by going to Start -> Accessories ->
System Tools.
2.If you are prompted by the Backup or Restore Wizard, I
suggest you un-check the "Always Start in Wizard Mode"
checkbox, and click on the Advanced Mode link.
3.Inside NTBACKUP's main window, click on the Backup tab.
4.Click to select the System State checkbox. Note you
cannot manually select components of the System State
backup. It's all or nothing.
5.Enter a backup path for the BKF file. If you're using a
tape device, make sure NTBACKUP is aware and properly
configured to use it.
6.Press Start Backup.
7.The Backup Job Information pops out, allowing you to
configure a scheduled backup job and other settings. For
the System State backup, do not change any of the other
settings except the schedule, if so desired. When done,
press Start Backup.
8.After a few moments of configuration tasks, NTBACKUP will
begin the backup job.
9.When the backup is complete, review the output and close
NTBACKUP.