how to calculate forefeiture of share when over subcription
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Is it possible to list only a portion of Equity Shares leaving the balance as unlisted?
What is Writable & WritableComparable interface?
What is Noise?
plz help me i want previous question papers of section engineer rrb electronics send me plz firstname.lastname@example.org
netmeeting in vista
Two or three Production Orders are there for the same day, and goods are not sufficient and then how to proceed?
what are application of paleosols.? Write at least 10 to 12 lines with meanningful sentences .
I renders interior Services, consider one project cost Rs.500000/- Scenario 1 - Material purchased on my Firm Name Material - 300000 -300000 On party behalf Labour - 200000 -150000 My expenses for Labour Contracts Profit - 50000 My Profit Scenario 2 - Material purchased by client Labour - 200000 -150000 My expenses for Labour Contracts Profit - 50000 My Profit In both Profit is same Rs. 50000/-. which is beneficial for me in terms of turnover or tax matters. and if I have to raise a bill to party as per both scenario, how it will affect bill and tax, where will I suffer loss?
why EMF IS INDUCED IN A CONDUCTOR WHEN FLUX LINKING WITH IT CHANGES ACCORDING TO FARADAYS LAW.
What is collective order. Pre requisite of the collective order?
how calculate gd2 of ht motors
what is the procedure of wet seiving. n percentage of silt in different type of soil?
Create an email to the customer for the damaged mobile phone... what is the answer req. in this mail