Company Name Starts with ...
#  A  B  C  D  E   F  G  H  I  J   K  L  M  N  O   P  Q  R  S  T   U  V  W  X  Y  Z

  • Alcatel aptitute test questions (2)
  • Alcatel interview questions (22)
  • Alcatel technical test questions (1)



Alcatel Telecom Protocols Interview Questions
Questions Answers Views Company eMail

What is protocol testing. whether u have used any tool in telecom testing.

8 40116

what'll happen if one isup link gone down? to brief this question...isup link is active between two nodes.if one goes down what are all the messages will be transfered to active node(bit wise,MTP wise)?

1 4611

Post New Alcatel Telecom Protocols Interview Questions



Un-Answered Questions

Rate analysis of Vitrified tile in cement mortor 1:3

2077


what is software engineer

883


Explain Structural characterization of soundness?

432


when you connect to DBM manager so which database is connect?

1511


In Remote acess server how u run a test?

601






Is it true that in the 3 phase transformer, the limbs of the core are at 45 dgrees to each other. if true, why?

829


I have given ielts exam and i got 5.5 bands and i also got three I-20s from the US universities, so my ielts score will interrupt my visa or not? I want to confirm it.

1128


1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.

715


why 14.7 pound/inch2 is used in idustries as unit of pressure bcz here not sea level and not a temperature is 0C (zero degree celcius)?????????

916


Please brief me future of ayurveda in India & abroad.

1741


My system suddenly get off,when i try to power on then it does not work but when i open it and clean RAM and insert it again, it power on.but after some day same problem? please give the answer (i have also changed RAM it's new.)

638


What pressure results for a flow transmitter of range 0- 180t/h in the dcs and 0-301mbar in the field using square root extraction. Kindly also suggest formulae for the percentages 0,25,50,75,100?

839


Any one can mail soft copy of Balance sheet,Trading and profit and loss alc.of a small firm or small co for study

1000


what is formula for zero phase sequence of nuetal earthing transformer of 6.6 kv

845


What are diffrent type of road taxes?

775






Alcatel Telecom Protocols Interview Questions
  • C (3)
  • C++ General (1)
  • Tcl (3)
  • SS7 (1)
  • Windows AllOther (2)
  • Linux System Calls (1)
  • Unix Commands (2)
  • Operating Systems General Concepts (1)
  • Manual Testing (1)
  • Telecom Protocols (2)
  • Electronics Communications (5)
  • Everything Else AllOther (1)
  • General Aptitude (2)