Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sachin
Transducer is a device which converts physical parameters
such as pressure,temperature and weight into electrical
signals.
| Is This Answer Correct ? | 11 Yes | 3 No |
Post New Answer View All Answers
Programmable Logic control.
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
kindly sent some demo question and answer
what is difference between HOT permit and cold permit
What are the different types of thermistors used in industries? How to the operation of typical thermistor?
Which topics are covered in Process Control?
Why boiler chimney area oxyden sensor fixing?
What is the difference between modbus,fieldbus & profibus
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Which is the best field foundation bus. ( FF ) Yokogawa, Honeywell or others ?
How to calibrate Toxic gas detector?
List three types Level Gauges with their working principles
what is gas metering system? gas chromatograph? and gas compressors?
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
what is exact time to study dcs and plc cources
