Answer Posted / saravanan.m
ZERO ELEVATION MEANS WHITE FIXING THE TRANSMITTER LOWER
THAN THE PROCESS LINE IT GOES NEGATIVE .TO CHANGE FROM
NEGATIVE WE ADJUST THE ZERO SCREW.
ZERO SUPPRESSION IS WHILE FIXING THE TRANSMITTER ABOVE THE
PROCESS LINE IT SHOWS ABOVE 4MA THEN WE ADJUST TO 4MA
| Is This Answer Correct ? | 32 Yes | 107 No |
Post New Answer View All Answers
what is the calibration procedure for transweigh make weigh feeder?
Gas equation
Specify ideal accuracy of flow element like orifice plate, Ventury, Annubar. Ultrasonic flow meter etc.
How d.p. Transmitter can be applied to close tank?
Why ac supply load cell is used? Can we use the dc supply load cell?
How to convert mmWc(mili meter water colam) to tph(ton per hour)?
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
why we use the ac supply load cell>?can we use the dc supply load cell?advantages and disadvantage of the ac supply load cell?
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
how to commission furnace ( water heater)
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
How many ohms are required for proper earthing?
Exothermic reaction./ endothermic reaction
What is three element drum level control system why its better than single element?
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
