Interested to Buy Any Domain ? << Click Here >> for more details...
what is purpose of using reactor in substations.
- 20 Answers
- 109794 Views
- Heavy Engineering Corporation Ltd HECL, I also Faced
- E-Mail Answers
Answer Posted / nabeel
it s to maintain the phase angle btwn volt and current. For
power factor correction actually. Also it can be said as To
control the reactive power flow.
| Is This Answer Correct ? | 27 Yes | 42 No |
Post New Answer View All Answers
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
difference between high and low impedance BUS BAR relay??
Why the unit sizes of hydro generating machines are not standardized as in case of thermal powerplants?
Could you measure voltage in series?
can we install HT panel & LT panel side by side or how much clearance is required ?
What is FTA card? How it works?
When can we take Neutral as common neutral link?
how give earthing conection to household equipment?
1. Design a counter which counts 0, 4, 8, 2, 6, and repeats using: 1.a using JK flip flops 1.b using T flip flops 1.c using D flip flops
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
why the colour of insultor stack , petticoat is brown. Is it has some technical reason.
CAN U PLEASE TELL ME SOME G.D TOPICS FOR APGENCO INTERVIEW&G.D
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
by what factor the starting current is used when comparing star and delta connection for motor starting?
