Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between general arc welding and
alumimium welding?
- 3 Answers
- 7216 Views
- I also Faced
- E-Mail Answers
Answer Posted / gurmeet singh
I aluminium welding, we have a aluminum oxide layer over
the metal surfae, which is genrally formed in free aluminum
surfaces. This oxide ;ayer is not removed by brushing. So
we have to use the cleaning action whichin the welding
process. So during aluminium welding, we use AC power
source, which given sine wave. This cause the breakdown of
oxide layer of aluminium.
And in general arc welding technology, we use DCRP or DCSP
i.e. reverse or straight polarity for welding.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
HOW TO calculate steam velocity on boiler o/l ?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
What causes turbocharger surging?
what is the use of vacuum balancing valve in CEP
What is the difference between Runout and Total Runoutvv
Why centrifugal pump is not called as a positive displacement type of pump?
what is over ball dimmention? why it is required? what is used in machining?
what will be the min curvature ratio for Round Bar dia. 1” size in material grade AISI 4330, Yield strength 115KSI Tensile 140KSI?
why desuperheater tubes are bend in shape
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
I have purchased some circlips @rs 100/- p pc on 01.01.2017 ans some @rs.120/- p pc/@rs.90/- p pc dt. 31.03.2017 what is the ending price of per pcs
Who invented springs?
Why pert is preferred over cpm for evaluation of project ?
give the sample format of boq plumbing materials
Question regarding property of Critical Path?
