wat is the importance of reactive power in power
generation.....if it is zero means wat will happen to
system........
Answer Posted / jnanesh
80% of our industrial loads use inductive loads i.e
induction motors .These inductive loads require reactive
power which plays an important role in maintaining magnetic
field inside the motors.so reactive power is necassary but
should be in a limit which in otherwise increses losses
Is This Answer Correct ? | 19 Yes | 5 No |
Post New Answer View All Answers
Define ampere
Why power genaration in India is at 50HZ while America its 60HZ
What is difference and reason b/w -48V BTS system and 24 V BTS system. Plzzzzzzzzz tel me.
where does 22kv line starts
The D.C. spark test is applicable to single conductor cable & assemblies of insulated single conductor cables without insulation shield,metallic sheath or metalic armor?
When are the directional relays used?
How does a transformer contribute towards the widespread popularity of ac system over dc?
define displacement & magnitude ?
What is meant by Im=30mA@Vk/2. How to know the kee point voltage for CT design
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
Why reactors use before incoming of ac vvfd drive?
What is corkscrew rule?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
how to calculate energy of 3-phase motor?