what is purpose of using reactor in substations.
Answer Posted / jnanesh
Reactor is nothing but having a wound coil inside it having
high impedence.Suppose there is an short circuit in
transmission line it limits the short circuit current to
safer value which prevents the connected equipment i.e
breaker or transformer.
Is This Answer Correct ? | 214 Yes | 29 No |
Post New Answer View All Answers
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
how point on wave controller works.
limitation of conductor height on ground when we consider EMC
At full load wat is the motor p.f And at no load will is the motor p.f?
How DC earth leakage currents can be reduced ?
how to design the heater in temperature control unit to heat 50KL of water?
How many turns are there in primary winding? (In Transformer)
which type of questions asking for solar companies?
What is transient response?
operation of diesel generator
How much load can be taken for chiller from 1500 kva transformer
Please, if 1kw is equal to 1.25kva; how then do I know how many kva in 7.5kw?
What is earth?
Vibromotor 252MV 1/4HP2P..what is mean by 252MV?
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?