What are the technical reasons for soaking transformers for
various times before allowing them to pick load after a
fault ?
Answer Posted / japjeev
The soaking process is to determine the sufficiency of the
cooling oil for continuous operation under temperature and
duty cycles.
If an outage occurs placing heavy load currents on a
transformer it must be assured that it will survive without
exploding, melt-down, etc
| Is This Answer Correct ? | 15 Yes | 15 No |
Post New Answer View All Answers
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
Efficient electrical earthing in hard rock area
R=*ΒΆ l/a
How delta connection in the primary of distribution transformer reduces harmonics?how delta connections reduces harmonics?Please answer me...Hope that question is correct.
HOW MUCH CURRENT DOES SYNCHRONOUS MOTOR TAKES AT SYNCHRONOUS SPEED IN NO LOAD CONDITION ?
when we design electrical schemes of 11/.415kv distribution..wen and were should we show the relays??what is the function of it?for example..we place EFR Relay CT between transformer neutral link and transformer earth.Like this what are the other type of relays we should use?why?where?Explain please..Thank you
11 kV line deraction check by an Engineer.
Pl. brief about break-down maintenance of machine tool.
What are the three constants associated with a steady state error?
WHAT IS THE FORMULA FOR CALCULATING CURRENT RATING(DIRECT IN GROUND OR AIR) OF ARMOURED(XLPE) CABLE OF 4C,16Sqmm?
WHAT IS MEANING OF Gg & Gg IN hrc FUSE
can anyone please help me to find the rupturing or breaking capacity in KA of circuit breaker (MCCB,VCB,ACB etc) of HT and LT side of a distribution transformer...please help with detailed step by step answer...thank you
Why hydropower is called renewable source of energy?
difference between crane drive and line drive.
Why is back emf used for a DC motor? Highlight its significance.