In case of a beam ,main steel is provided along the longer
span because, bending moment is directly proportional to
length but why in case of one way slab main steel is
provided along shorter span while as bending takes place
along longer span?comment
- 5 Answers
- 10411 Views
- Power Grid, I also Faced
- E-Mail Answers
Answer Posted / kannan
This is because the deflection of the oneway slab is more
on shorter side. Example if you take 30cm plastic / steel
scale, apply the load longitudanoly, immidiately deflecton
takes place over the particle. Hence to avoid the
deflection of slab, main reinforcements are provided in
shorter span.
| Is This Answer Correct ? | 6 Yes | 4 No |
Post New Answer View All Answers
HOW MUCH STEEL REQUIRED FOR SLAB OF AREA 23'3"*18.3"? FOR SLAB HOW MUCH DIAMETER BAR WILL USE?
How to calculate cement and river sand material Qty for waterproofing base coat and finish coat
manhole height is 1500 mm and width of brickwork is 230 mm dia of manhole covering is 560 mm brick masonry 1:4 horizontal length is 1500 mm and plaster 12 mm thick on both side 1:3. how to estimate the quantity of brickwork with mortar cement and sand for manhole chamber.
Define unit atmospheric pressure? Difference between gauge pressure, absolute pressure?
acceptance criteria for concrete works
57. Calculate the volume of a truck loaded with stone chips whose data are as follows– 5 Top Length - 13-9, 13-10, 13-09 Bottom Length - 13-11, 13-10.5, 13-10 Top width - 8-7.5, 8-8, 8-7 Bottom width - 8-7, 8-8, 8-7.5 Depth - 2-0, 1-11.5, 1-10, 1-11, 1 -10.5, 1-11.75, 1-11
Which prize is the alternative to the NOVEL Prize?
what is the ingredient value of 40mm and 20mm aggregates?
How much area will be covered in 1 litre of Velvet touch paint in normal wall condition
What is an object snap mode?
explain five benefits of using standard terminology in the measurement process?
Why joints are provided?
weight of 1 cft 10mm, 20mm, 40mm aggregate weight of 1cft course sand
What are the different methods for drawing an arc?
Does degree of bend of rebars has any effect on strength of the member? For example- if a beam is designed with 45 degree bent up bar with respect to architechtural needs and is not 45 in practical so will there be any reduction in the strength of member?
