why heat produced at junction of two different conductor.
what care should be taken to minimize it.
- 11 Answers
- 15000 Views
- Birla, Maihar Cement, I also Faced
- E-Mail Answers
Answer Posted / pradeep kumar rawat
at the junction of two conduntor some gap are formed at the
junction point, due to this gap some air take place and
ionised by other ions which is flowing in two conductor,air
between two conductor ionised and current posses through
one conductor to other conductor and heat produces, due to
this at the junction of two conductor heat produced.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
Explain about 3 phase motor fault current calculation with examples?
TRAFO 1. WHY BREATHER IS USED. 2. WHY OIL GOES DOWN IN CONSERVATOR TANK. 3. WHY WE ARE TAKING OIL SAMPLE TAKING FROM BOTTOM OF TRANSFORMER. 4. HOW TO CHECK IR VALUE OF TRANSFORMER. 5. WHY OLTC HAVING BUCHHOLZ TRIP ONLY; WHY NO ALARM. 6. OFF LOAD TAP CHANGER OPERATION PROCEDURE. 7. TR. SHUTDOWN / ISOLATION PROCEDURE. 8. WHEN THREE TRS. IN PARALLEL, ONE TR. IS NOT SHARING THE LOAD – WHAT IS REASON AND WHAT YOU WILL DO. 9. WHY TR. HAS OLTC IN HV SIDE. 10. WHAT IS % IMPEDANCE. 11. WHY TR. RATING IN MVA. 12. WHAT IS VECTOR GROUP IN TR. 13. CONDITION FOR PARALLEL OPERATION OF TRS. 14. WHAT IS TERTIARY WINDING. WHERE IT WILL BE. 15. IF TR. TRIP ON BUCHHOLZ OR TAP CHANGER RELAY, WHAT YOU WILL DO. 16. DIFFERENCE BETWEEN OIL TEMP. AND WINDING TEMP. PROTECTION 17. HOW WINDING TEMP. IS MEASURED IN CAST RESIN TR. 18. DIFFERENT TYPES OF FAULTS IN TR. Trafo - Page-1 of 2 19. WHAT HAPPENS WHEN TR. CHARGED FROM LV. 20. WHAT WILL YOU DO IF MEGGER READING SHOWS ZERO BETWEEN LV WINDING AND EARTH. 21. CAN WE INTERCHANGE BUCHHOLZ RELAY OF MAIN TANK AND OLTC TANK. 22. IF THE LINE BETWEEN BREATHER AND CONSERVATOR TANK 23. LOCKED, WHAT WILL HAPPEN DURING LOAD CYCLE. 24. WHAT IS THE FUNCTION OF OIL SEAL IN BREATHER. 25. WHAT ARE LOCATIONS FOR BUCHHOLZ RELAY FIXED IN POWER TR. 26. WHAT ARE CHECKS IN POWER TR. DURING MAINTENANCE. 27. WHAT IS IMPORTANT WHEN WE CHECK OLTC OPERATION DURING MAINTENANCE. Trafo - Page 2 of 2
Give the topology of current amplifier with current shunt feedback?
why we permissive overreach in distance protection.where it is applicable to use in long r short lines
How do we arrive at selecting reactive capacitance value as 30% of h.p rating of motor?
what is the standard duration after failure EB power
what is the effect of back reactive power on the generator ?
What is the effect of positive feedback on stability of the system?
what is th basic difference between a d latch time line and a d flip flop time line???
how to calculate maximum current
what is the use of sdf?
what is the formula of starting current of 3phase and 1 phase motor???
What are the advantages of instrument transformer?
why to use freewheeling diode ( diode in revers bias mode) across dc coil
why the NGR (neutral grounding resistor) always OFF during DG off?
