what is difference between differential protection and
distance protection and how we calculate the sloop?
Answer Posted / vel
differential relay works on the principle of kirchoff
current law. i.e incoming current = outgoing current if it
is not equal relay will give trip signal.it is used for
transformer and generator protection.
distance relay works on the principle of z=v/i. when z
value of the line fall below the set value relay will give
trip signal. it is used for tranmission line.
| Is This Answer Correct ? | 100 Yes | 6 No |
Post New Answer View All Answers
What is error of a measurement?
What is the effect of pi controller on the system performance?
how to find ratio of CT & PT in 66/11kv 12 mva supply system ? explain with calculation.
What is line resistance of cable & how it can be measured ?
which book to refer in electrical engineering for iocl exam & which book for general english.
Earth bits close or open. Which is correct
How you calculate the repturing capacity of a HRC fuse
what is die electric strnth of transformer ?
what is the defination of Cable database? What are the points are considered while preparing cable database? Is there any sample available for cable database?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
2. What are the parameters of EHT sub-station?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
State thevenin’s theorem?
What is the principle of HIGH SPEED DIRECT DRIVE MOTOR ?