wat is the importance of reactive power in power
generation.....if it is zero means wat will happen to
system........
- 22 Answers
- 37573 Views
- Bhel, Jindal, I also Faced
- E-Mail Answers
Answer Posted / harsh
reactive power just flows in ckt........from source to load
&load to source...if it increases then reduces the power
carrying capacity of line.........
| Is This Answer Correct ? | 3 Yes | 10 No |
Post New Answer View All Answers
Is there chopping current in resistive circuit
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
A well system is when , no. of bus bar is less or more. Tell me the concept of it.
when we design electrical schemes of 11/.415kv distribution..wen and were should we show the relays??what is the function of it?for example..we place EFR Relay CT between transformer neutral link and transformer earth.Like this what are the other type of relays we should use?why?where?Explain please..Thank you
for a 400kv t/m line with 10 ampere current will corona occur?
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
How could a garment factory benefit from renewable energy
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating
WHAT IS MEANING OF Gg & Gg IN hrc FUSE
what is allowable ac mixing in dc
how to discharge 3 phase power factor correction capacitors
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
how to set relay setting? and example calculation...
If symmetrical fault occurs at the terminal of a synchronous motor then how the motor will act...explain it..
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
