What should be hight of CONTROL panel for access &
OPERATION
What is BIS & INDIAN STD for SAME?
Answer Posted / sagar.tinkhede
The standard Height for Control Panel is 2200(H)X 1000(W)X
800(D).
Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
sir, give me placement papers and interview quistion of birla group company of copper.
What is instrumentation technologists and mechanics?
Calibration of controller (pneumatic)
Exothermic reaction./ endothermic reaction
Linear amplifier.
Which language of programing is popular? how can i learn it ?
Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?
Calibration procedure for water rotameters
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
I will attend an interview with GasGas company for a position of Instrument Technician ( Offshore )in next month can anyone tell me what questions they will ask. Thanks in advance.
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
what is a half wave, full wave, and bridge rectifer.
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card