wat is the importance of reactive power in power
generation.....if it is zero means wat will happen to
system........
- 22 Answers
- 37437 Views
- Bhel, Jindal, I also Faced
- E-Mail Answers
Answer Posted / gobi
AC power can be classified in to active power and reactive
power.
importance of reactive powers are to Maintain and control
the voltage balance on the system, Avoid damage to the
Transmission System, Generation plant and Other connected
parties•
The provision of Reactive Power by all Generation Units for
voltage support is vital to maintain a secure and stable
Transmission System.
If reactive power is zero then the power factor will be
maximum that mean full utilization of power.Maximum power
utilization is the basic necessity for power system.
| Is This Answer Correct ? | 34 Yes | 27 No |
Post New Answer View All Answers
what is different between relay and plc?
Good day everyone,currently in our premise we using 30kw slip ring motor with resistance bank which we use as forward and reverse at conveyor bar handling. So,my question is how do we calculate the resistance bank which is suit the motor. Kindly,assist me... thank you
for 4 MVA , 33K.V/6.6K.V transformer. secondary side the connected load is 3000H.P. What is the rating of capacitor bank to be insttaled.
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
What is Harmonics how it is produced and what is the method to control the same
Single line digram for 11 kV to distribution use go,la and do
y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..
can anyone provide me a amf panel control wiring using ec-2 relay?
how to determine Sq.mm size of finolex power cables.
What difference between ref protection and differential protection ?
What are the three types of compensators?
How does the phase sequence controller works, how it identifies the phases? confirm working principle
what is the differance between HT motors And LT MOTORS.
how is working bearing heater?
what is the Connected Load (kW) or Contract Demand (kVA)of mahindra nasik plant??
