Interested to Buy Any Domain ? << Click Here >> for more details...
condider as 100 w lamps glowing . for completing a one unit
how much time it should glow
- 3 Answers
- 19073 Views
- Avalon, I also Faced
- E-Mail Answers
Answer Posted / vijay
1 unit = 1kwh = 1000wh
100w = ? hours
1000wh/100w = 10h
watt and watt gets cancelled hour remains.
so it takes 10 hours for a 100 watt bulb to complete 1 unit.
| Is This Answer Correct ? | 61 Yes | 3 No |
Post New Answer View All Answers
how to failure indution motor insulation & how to improve heat in motor insulation
For a stable system, where should the poles of a system be in a root loci plot?
How many types are using in 220kv/400 kv swith yard
what is the differance between HT motors And LT MOTORS.
During regenerative breaking= A rotating magnetic field is reversed B slip is positive C torque is positive D slip is negative
Difference between transition and diffusion capacitance
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
How does a battary stores charge in it? please explain in simple manner and in detail.thanks
What are the various kind of cables used for transmission?
How to Calculate the Fault Level of Electrical Installation
what is the difference between 50 hz freq. and 60 hz freq.? which is better and economic in them ?
What are the basic & Majour problems in UPS ?
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
How to determine the breaking capacity such as break down current and break down voltage for VCB and CT's.
WHat is the requirement of installing FAST ACTING EARTH SWITCH in GIS and how is that integrated with protection system. How and when does it operate?
