Interested to Buy Any Domain ? << Click Here >> for more details...
what is the technical diffrences of mccb and acb
- 11 Answers
- 23210 Views
- TransWorks, I also Faced
- E-Mail Answers
Answer Posted / dudeblore
MCCB- moulded case circuit breaker
ACB - Air circuit breaker
Normally ACBs are being used in high current systems where
as MCCB with current less than 1500A. The main difference
depends on the arc quenching meddium. In ACB air is used as
arc quenching medium and MCCB will be operated like other
breakers like MCBs, etc...
| Is This Answer Correct ? | 18 Yes | 21 No |
Post New Answer View All Answers
If rotor works in clock wise what happens
why the India electrical supply transmission loss is high when compare to us
what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..
when will be the iocl interview results ifaced the interview on september 8 th
Differentiate between digital phase converter and ordinary phase converter.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
draw the block diagram of fire alarm?
What range of speed can you get with the field control method of speed control of d.c. Shunt motor?
I WANT YHE TECHNICAL AND ELECTRICAL SPECIFICATIONS OF 2x4MW 11KV 2x10MW 11KV 2x25MW 11KV 2x100MW 11KV HYDEL POWER PLANT i.e PROTECTION SYSTEM,MONITORING,CONTROL SYSTEM,GENERATION,SYNCHRONISATION,METERING PLEASE SEND THE DETAILS TO MY MAIL ID SPRAVEEN_222@YAHOO.CO.IN
How to decide CT & PT ratings for a given transmission line carrying some rated voltage?
Whar is the KvA rating of 33Kv substation & actual kv rating of power generaating station.
What is nichols chart?
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
2. What are the parameters of EHT sub-station?
What is the emf equation of a transformer?
