Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / viji
It is a device which converts physical quantity into
electrical energy e.g RTD , Thermocouple
| Is This Answer Correct ? | 14 Yes | 4 No |
Post New Answer View All Answers
typical loop drawing of a simple feedback control comprising of one transmitter and one control
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Why boiler chimney area oxyden sensor fixing?
plz send me general of ongc
What is hp & mp seperator .& what is its working principle ?
hi! i want to know about mpse exam.
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
What is instrumentation measurement?
Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...
Explain PID, ON/OFF, Controls
how to design orifice plate?what is the equation?
What is the difference between working pressure and calibration pressure of a control valve
What is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
