Answer Posted / shailesh bhat
BASICALLY DEPTH OF FOUNDATION IS ALWAYS DECIDED BY TYPE OF
FOUNDATION.IF IT IS SIMPLE SPREAD FOUNDATION THE DEPTH IS
0.9-1.0 AS PER THUMB RULE,IN CASE OF PILE FOUNDATION IF
FRICTION PILES ARE PROVIDED 2 MT DEPTH IS SUFFICENT WHILE
IF LOAD BEARING PILES ARE PROVIDED U HAVE TO GO DEEP UNTIL
A LOAD BEARING HARD STRAUTA IS NOT OBTAINED USUALLY IN
RIVERS.IN CASE OF RAFT FOUNDATION ,I THINK LOAD BEARING
AREA OF RAFT MATTERS.
Is This Answer Correct ? | 50 Yes | 24 No |
Post New Answer View All Answers
What is the cost difference between site mix and ready mix concrete per cubic meter
How to find permissible diagonal tensile stress in reinforced brick work
how to balance aggregate during mix design of concrete???? how to calculate moisture content like C/A,F/A and how many percentage using ice instead of water for example of we are preparing ice concrete??????
What is alternate bid?
What is semirigid connections?
what is the productivity in aluminium shuttering per day
What is a tensile strength? What is the tensile strength of wood?
how lap length is increased with increase of Grade of steel?
What is the absolute pressure scale?
how to calculate cut length of re-bar in a circle . because we not place same length of re-bar in whole circle maximum in center and minimum at corner so how to calculate middle bars???
Trapezoidal section footing calculation of Volume & its Area
in staad ,why we realease a moment of a member ? what is affect if we realease a moment
What you understand by richter scale?
what is the anchorage length of reinforcement.
Elaborate advantages & disadvantages of using crusher dust instead of sand in rcc work.