Interested to Buy Any Domain ? << Click Here >> for more details...
a bulb of 100W and anather bulb of 200W , rated supply
voltage 230v.when supply voltage is reduced to 100v,which
bulb will give more light? and why with calculation?
- 12 Answers
- 36277 Views
- I also Faced
- E-Mail Answers
Answer Posted / vasanth
100w bulb will give more light
due to p=v*i, i=v/r.
calculate R value
lighting will related to heat loss
calculate heat generated /100 volt
| Is This Answer Correct ? | 13 Yes | 15 No |
Post New Answer View All Answers
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
Explain the function and difference of Restricted earth fault, simple earth fault and sensitive earth fault with connection diagram.
If one tertiary phase i.e. R,Y or B is earthed of a loaded type tertiary delta connected (Without load)of a power auto transformer, what is its advantage/disadvantage?
Do closed loop systems require manual input?
i need of the bhel question papers along with answers and also give some website names for the downloading question (electrical and electronics engg question)please help me....
What are the different types of hydro schemes?
What is electrical cable termination
which type of stability limit is higher,steady state or transient? why?
how can i find cable size from current rating?
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
please explain how to do 'pole drop test' on generator?
i need to now what will be the cable size to the following load, transformer to distribution panel distance 110m, load 1000kw, voltage 400v, pf 0.85, permissible voltage drop 2.0%, overhead line, atmospheric temperature 35 degree c.
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
How many turns are there in primary winding? (In Transformer)
Logic using 1 kV or 1,1 kV grade in house wiring Low voltage cable. Explain/suggest? some use 1kV and some prefer 1.1kV grade insulation low voltage cable why??
