what is the difference between electrical & electronics
Answer Posted / najeem.a
Electrical is the study of charges in a conductor and deals
with high amount of current with low frequency.
Electronics is the study of charges in Vacuum,liquid and gas
also it deals with low amount of current with high frequency.
Is This Answer Correct ? | 57 Yes | 53 No |
Post New Answer View All Answers
Why is water motor not taking the pressure? what is the problem?
What is tan delta & PPM in transformer? and whats its IS value?
how invertor convert the dc into ac give brif detail
I want to put this query to SENIOR & EXPERIENCED ELECTRICAL ENGINEERS. 1)I want to know about the control circuit diagrams for control panels. I found it difficult to understand. Is there ant booklet through which we can learn the circuit diagrams? 2)I want to learn about conduiting, laying cables, preparing cable schedules and various techniques which is the part of building infrastucture(construction field). I don't have any experience in this area. I have experience in control panels only. that's why i am not getting any opening in building infrastucture (construction field).Can I get the job in this field as Trainee Engineer? How to enter this field? I need job in PUNE
How to decide CT & PT ratings for a given transmission line carrying some rated voltage?
Two electric lamps 40 W, 220 V each are connected in series across 220 V. What is the power consumed by the connection?
What is purpose of reactor?.What is different between line and bus reactor?
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
how much allowable resistance that can be difference in motor all coils?
what is droop control?
What is the tube exial fan?
in conventional fan regulators how the current varies with speed?
full form of electrical?
sir i have a car stereo system and there is jack on him so can u tell me a way to find out their power terminals on the jack or on the circuit board"
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.