WHY THE FREQUENCY IS 50 HZ IN INDIA.CAN WE USE SOME OTHER
FREQUENCY.IF SO WHAT IS THE RANGE AND WHAT WILL BE THE
EFFECT IN PRESENT POWER SYSTEM IF WE CHANGE THE FREQUENCY
AS YOU SUGGEST ?
- 32 Answers
- 48656 Views
- L&T, MCL, I also Faced
- E-Mail Answers
Answer Posted / vijaya kumar
if we choose other freequency suppose 60hz ,our standara
freequency is 50hz.for transfer of power there must be same
freequency.Also if freequency increases number of poles
also increases,if poles inc.d diameter of equipment also
inc.it leads to high cost.
| Is This Answer Correct ? | 34 Yes | 45 No |
Post New Answer View All Answers
wow to calculate the transformer rating(KVA)
Where is servomechanism used?
BSNL TTA EXAM QUESTION
primery try cell?
ht side line to earth voltage
why the name trunking bus PT
If Neutral Grounding Resistor (GR) failed/shorted. Is it repairable.
How to run a three phase motor into single phase........
If an electrical component has a positive temperature coefficient, how come such components have high power losses due to heat if current decreases when resistance increases? assuming power given by I^2*R whereby the Resistance is infinite.
Why different Pressure switch used in marine boiler water circulation system
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
what is working process of star delta controlling circuit ?
how can i use REF and diffrencial relay both in 1 CT core for transformer protection?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
why ct's&pt'S out put called as burden,why compelsary short ckt the secondary of ct's while removing the burden?
