Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ruchita
An electrical engineer is one who have electrifying
solution to critical problems.
they have the visualization capability more than anyone
else, as, in this field nothing can be seen. all based on
imagination and it rules the other engineering....
| Is This Answer Correct ? | 0 Yes | 6 No |
Post New Answer View All Answers
How to design harmonic filter at the project stage without nowing the harmonics levels
Why the unit sizes of hydro generating machines are not standardized as in case of thermal powerplants?
Maintenance of transformer???
how to decide choke rating for drive?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
how does an centrifugal and screw type chiller will work. which chiller efficiency is high and why.
Circuit diagram of tube light without starter using electrical choke
what is earth resistance? how to measured? and give values at power station and mcc area?
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
Define Electrical Insulation and examples of Solid,Liquid and Gaseous insulating materials?
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
how will reduce the voltage. if 12volt/250ma transformer toreduce 6 volt
IF HT CAPACITOR IN ON POSITION IS THERE ANY LOSSES I.S I SQURE OCCURS IN THE SYSTEM
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
