Answer Posted / pradeep
a link is considered to be the simple machine,on combining
the links, which has the relative motion between them, a
mechanism is obtained.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
What is the difference between Maintenance Order and Production Order. the point is i want to know the affection of Movement type 261 thru maintenance order and Production order. if i change any settings for Maintenance order it will affect to production order process also for 261 movement type ?
What is general pressure ratio for axial, reciprocating and centrifugal compressors?
How much pressure on air reservoir?
difference between internal energy and enthalpy?
Whether individual components in composite materials retain their characteristics or not?
what should be the correct duration of slow firing of the coal based and biomass boiler?
Under what circumstances would there be an increase in pressure in a diver¬gent nozzle ?
What is the use of flash chamber in a vapour compression refrigeration cycle to improve the cop of refrigeration cycle ?
why we r recommended for pre-action sprinklers @ generator/tx/mv panel room. If any leakage there,that panel will damage. So what is the Logic for pre-action sprinklers there?
If gas turbine is operating on part load, how droop will affect the output with respect to frequency.
Assume a DC motor with the following parameters : Motor torque control = 0.0848 Nm/amperes Back EMF control = 0.0848 Volts/(rad/s) Armature resistance = 0.75 Moment of inertia = 0.00001696 kg/m2 With zero frictional load and taking a feed forward gain of 2, determine the motor response for a unit step function. please forwaded the answer to the below mail id thanks in advance Regrads, peer_kaba@yahoo.co.in
What are the causes of turbine vibration
Why is thick steel wire stronger than thin steel wire?
Explain the fresh water cooling system.
In a rankine cycle if maximum steam pressure is increased keeping steam temperature and condenser pressure same, what will happen to dryness fraction of steam after expansion ?
