Interested to Buy Any Domain ? << Click Here >> for more details...
can you give main difference between ELCB And RCCB?
- 38 Answers
- 171624 Views
- MCB Bank, Reliance, Wipro, I also Faced
- E-Mail Answers
Answer Posted / sabarikumar r
ELCB is a voltage operated device.RCCB is a current
operated device.IN ELCB, Trip coil is connected between
system ground and non current carrying part of the
machines.RCCB having CBCT(Core Balanced Current
Transformer).CBCT consists of 2nos of primary winding
(P1,P2) and one secondary winding(S1).Primary windings are
in series with the load and secondary winding connected to
Trip coil.In case of healty time, voltage in both the
primary windings will be cancelled and hence no voltage on
secondary winding.During the leakge or If any body touch
the live wires of the machines, current will passing
through the body and connected to ground.It will cause the
voltage difference in primary windings and induced voltage
in secondary operates the trip coil(operating time 50ms).
| Is This Answer Correct ? | 220 Yes | 48 No |
Post New Answer View All Answers
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
Differentiate between ideal and non ideal current sources?
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
hwat type of motor is used in thermal gas turbine hydro nuclear power plants and why
What is the comparison of PILC and XLPE cable
The electromagnetic torque developed is proportional to what in a D.C series motor?
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
what is the value of combined earthing in general electrical circiut?
what is meant by residual over voltage & residual earth fault ?
how diside ct mf exmp.200/5 ct
how many joint can done in HT line and what is life of the joint
Define the overload capacity of the motor?
how we test a 3 phase motor on single phase supply....? HOW WE RUN A 3 PHASE MOTOR ON SNIGLE PHASE. supply for testing..? how we verify of a 3 phase motors 6 wire & name thame a1/a2/a3..b1/b2/b3 and c1/c2/c3 for connecting star delta starter ........i have only 1 phase supply ? help forum..........
