Interested to Buy Any Domain ? << Click Here >> for more details...
In Ferranti effect,Receiving end voltage is greater than
sending voltage,why? can anybody tell me the answer
- 15 Answers
- 50547 Views
- Engineers India Limited, I also Faced
- E-Mail Answers
Answer Posted / john
Due to the power loss.
| Is This Answer Correct ? | 2 Yes | 69 No |
Post New Answer View All Answers
Why GRR starts from 60% of motor speed why not less than 60%?
Hello everyone, somebody knows what is a "surplice power" ? The hole phrase is: "This rating is appropriate for a generator set paralleled with an infinite bus e.g. a national electrical supply network or grid where the generator set is run at 100% load, 24 hours a day, 365 days a year and any surplice power is exported into the grid" Thanks in advance.
WHAT IS IM (INDEX OF MOUNTING )IN MOTORS
how to calculate cooling requirement of datacentre from electrical load?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
what is ps impedance test
Why we used 690V in ACS 800 drives.Why dont use standard voltage like 415v or 1.1Kv
what are the interview question asked in wind mill about electrical
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
I am about to write exam in RRB bangalore for the post of section engineer.please provide me with previous exam questions
What is the most accurate way of testing ELCB?ELCB is better than RCD?
What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?
what is the difference between interconnection and intraconnections in the circuit diagrams
what is the difference between circular wdg & ractangular wdg?
what is interpose? where it is used and why it is used?
