Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / gaurav naik
Since here ther is no power factor into play
we can make use of ohms law
R=V/I
or
P=I^2*R
| Is This Answer Correct ? | 43 Yes | 14 No |
Post New Answer View All Answers
What is the normal phase difference between the voltage and the no-load current in a transformer?
What is Instantaneous Earth fault relay,how will work
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
What is pole of the system?
What are protections for dty type transformers
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
Why front mounted CT polarities are always towards breaker?
what will happen if OLR CT in all phases are short circuted
what is the difference between torque induced and torque load?compare them with respect to dc motor?
Best way to measure the Soil resistance of rocky soil, three probe method and four probe method
What is cable tray, its type, and its support?
how to calculate the battery AH
What is a dc motor?
How to design a Unit auxiliary transformer for a power house having a unit of 65 MW and Generating voltage of 11 KV and Secondary voltage of 433V
