Interested to Buy Any Domain ? << Click Here >> for more details...
how bridge design is to be start?
what is the preliminary step for design?
which code of practice is to be used for design?
what r the methods used for design?
what r the ivestigation r carried out?
what r the design criteria for design and loading conditions?
- 1 Answers
- 7867 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajkumar
Hi friend,
Designing of bridges goes in following steps:
1) selecting suitable location after sufficient geographic
survey, hydrological survey, geological survey,etc.
2) after selecting the location you have to decide what
type of bride will be suited for ex. steel or arch or RCC
or prestressed, etc. depending upon length of bridge,
geological conditions, purpose etc.
3) once the type is decided then comes the part of load
considerations as under:
* DL, LL, Wind induced Loads, Earthquake induced loads,
hydraulic forces, centrifugal forces if any, upthrust,
stresses due to thermal changes etc etc...
* for this some IRC Specifications are to be followed.
4) after load calculations and various load combinations
the individual members are to be designed.
I hope this answers your question....
for more information look out in text "Bridge Engineering
by S.P.Bindra"....
| Is This Answer Correct ? | 14 Yes | 1 No |
Post New Answer View All Answers
how much of quantity of material required for execution of one cubic meter of random rubble masonry in 1:3 cement mortar
is there any thumb rule for calculating construction cost of the building with pile foundation per sft. area?
What ingredients with% found in ppc cement??
how do i remedy a foundatiom that the column bases was cast and aftet 28days crushing the conprehensive strength of the concrete fall below the specification 25N/mm2
how to calculate the strength of rebound hammer test reading in building construction ?
What are the advantages of building a dam on the river nile?
why demand factor less then 1 ?
how to caliculate required amount of cement and sand required for 1cu.m.
How to calculate dry of volume of concrete constant?How it comes 1.54 or 1.57
Why M15 is replaced by M20 when ammendment are made in IS456 in 2000?
plz.show development and anchorage length in simple diagram.
Sir how to find cutting length for footing steel bars in the shape of "u"
how many time use of plywood shuttering and IS code
What is .Dwg?
what are the five benefits of using standard terminology in the measurement process?
